0 items in your basket
Total £ 0.00 EX VAT
Multi Process Welders
MIG Torches
TIG Torches
Welding Helmets
Welding Gloves & Clothing
MMA Electrodes
MIG Wire
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Answers on choosing drive rolls, leads and clamps, torches and a trolley to go with a compact MIG welder.
Match the groove shape to the wire. A V-groove roll is the usual choice for solid steel and stainless wire. A V-knurled (toothed) roll grips gas-shielded and self-shielded flux-cored and metal-cored wires, but it is not normally used on solid wire because it can shave it. A U-groove roll is designed for aluminium and other very soft wires, because it feeds them without deforming them.Roll names vary, so check the feeder manual for which rolls fit your machine before ordering.
Choose rolls whose groove size matches the wire diameter you will use. Rolls often carry two sizes, one on each side, so check the marking and fit the right one to the front.A common method is to release the tension fully, feed the wire against a block of wood while winding the tension up until the wire slips, then add a little more. Reset the tension whenever you change the rolls. Too little tension lets the rolls slip, while too much can deform the wire and shave debris into the liner. Always follow your machine manual.
Attach the return clamp as near to the welding arc as possible, directly to the workpiece or the bench it sits on. Keep the contact surface free of rust, paint and oxide, and make sure the clamp is firmly secured.Extraneous conductive parts, such as structures, wire ropes, slings or chains, should not be used as part of the return circuit unless they are the workpiece itself, because stray current can flow through places you did not intend. Check the clamp and its connection regularly during long jobs.
Leads, connectors and holders should be checked at regular intervals for fitness for use, and damaged or worn parts should be repaired or replaced. A quick visual check for damage before each shift is good practice, and any fault should be reported. Do not tape over damaged insulation, and keep connections clean and tight.Use a holder that is insulated overall, so that no bare metal can be touched by accident. Do not rest a hot holder on flammable material. Check the rating marked on the holder against your machine.