Kemppi Minarc 150 Machine Parts FAQs
Practical answers on choosing, fitting and looking after replacement parts for a compact stick welding machine.
Can I fit a new mains cable and plug myself?
Only if you are competent to do electrical work. The law expects anyone doing work where technical knowledge is needed to prevent danger to have that knowledge or to be properly supervised, and a welder's mains cable carries the full input current. Makers generally say a mains cable should be replaced by a qualified electrician or an authorised service agent.
When buying a replacement, match the cable to the data plate and manual: cable type, conductor size, plug and fuse must suit the machine's input rating. Never swap in a lighter household lead, and never keep using a damaged cable. After the work, the machine should be inspected and tested before it goes back into use.
How can I tell that the mains cable or plug is worn out?
Look before each use, with the machine unplugged. Signs include cuts, crushing or scorching on the sheath, the cable pulled out of its clamp, exposed conductors, a cracked or loose plug body, bent or discoloured pins, and a plug that feels warm in use.
A brief user check is a recognised part of looking after portable electrical equipment, and most electrical defects can be found simply by looking. Do not mend a damaged cable with tape. If you find damage, stop using the machine, unplug it and have the cable replaced by a competent person. Machines that are dragged or carried by the lead tend to suffer sooner, so keep strain off the point where the cable enters the casing.
Why do the output sockets matter, and when should they be replaced?
The output sockets carry the full welding current into the leads, so a poor connection heats up. Welding guidance says external connections should be clean and tight, checked regularly and after every reconnection, and that connectors should be insulated and suited to the current they carry.
Signs of trouble include a plug that wobbles or will not stay locked in, discoloured or melted insulation around the socket, pitting or burn marks on the metal, a socket that is hot after short use, and an unstable arc. Do not carry on welding with a hot or loose socket. Replacing one means opening the machine, so it is a job for a competent person. Match the connector type to the leads you use.
What checks should follow a repair or part replacement?
Start with a visual check: covers fitted, cable clamped, no loose screws or stray wire. Some faults, such as a poor earth connection or weak insulation, cannot be seen, so after repairs involving electrical parts the machine should be inspected and tested by a competent person using suitable test equipment. A standard exists for inspection and testing of welding power sources after repair.
Keep a note of what was changed and when. Then make a trial weld on scrap at a modest setting, watching for unusual smells, noise, heat at the sockets or an unstable arc. Stop and unplug the machine if anything seems wrong.