Brazing Flux FAQs
Straight answers to the questions people ask most when choosing and using brazing and soldering flux.
What does brazing flux do and why do I need it?
When metal is heated in air, it forms a surface oxide layer that stops the molten filler from wetting and bonding to it. Flux dissolves and keeps out these oxides while you heat the joint, so the filler metal can flow smoothly into the gap and make a sound bond.
Without flux, the filler tends to ball up and run off instead of flowing into the joint. Flux does not replace cleaning, but it is what lets the filler wet the metal.
How do I choose the right flux?
Choose the flux to match the filler metal, the metals being joined and the temperature you will work at. Fluxes are made for particular jobs: silver brazing, bronze brazing, aluminium, stainless steel and soft soldering each have their own types, and they are not interchangeable.
The filler maker normally says which flux to use with a given rod. Check the pack for the metals it is intended for and for its working temperature range, and make sure it covers the temperature at which your filler melts and flows.
Do I need flux for every brazing job?
Most brazing needs flux, but some filler metals are self-fluxing in certain uses. For example, copper-phosphorus rods can be used without flux when joining copper to copper, because the phosphorus does the job. They still need flux on brass and bronze, and they are not suitable for joining steel.
Some aluminium fillers carry flux in the core. Always check the instructions for the rod you are using, and use flux where there is any doubt.
How do I know when the joint is hot enough to add the filler?
Watch the flux. As the joint heats, most brazing fluxes bubble, dry out and turn into a clear, watery liquid when they reach working temperature. That is the signal that the metal is ready for the filler.
Heat the parent metal, not the rod, and let the heat from the joint melt the filler as you touch it on. If the filler does not flow, the joint is probably not hot enough, or the surface is not clean.