Leather Welding Clothing FAQs
Straight answers to the questions people ask most when choosing and using leather welding aprons, sleeves, spats and jackets.
What leather welding clothing is there, and what is each piece for?
The main pieces are the jacket, apron, sleeves, trousers and spats. A jacket covers the upper body and arms. An apron protects the chest, front and lap, and is quick to put on. Sleeves protect the arms and are often worn with an apron. Trousers protect the legs, and spats cover the tops of your boots and laces.
Choose the pieces by where spatter and heat will hit you in the job you do. Light bench work may need only an apron, while overhead or heavy work needs a lot more cover.
Should I choose an apron, a jacket or both?
An apron is light, cool and easy to put on and take off, and it covers the front of the body where most spatter lands. A jacket gives more cover to the arms, shoulders and back, which matters for overhead or all-round exposure.
For light welding in a fixed position, an apron may be enough. For heavy work, positional welding or cutting, use a jacket or an apron with sleeves. Your risk assessment should decide, based on where the hot metal will go.
How should sleeves be worn?
Sleeves protect the forearms and upper arms and are held on with elastic, ties or fasteners. They should be snug enough to stay in place when you lift your arms, but not so tight that they cut off circulation.
The key is to leave no gap between the sleeve and the glove and between the sleeve and the shoulder or jacket. Think about which way spatter will fall, and arrange the overlaps so it runs off rather than into a gap. For overhead work, check that the overlap still works with your arms raised.
What are spats for, and how should they be worn?
Spats are leather covers that fit over the top of your boot and laces. They stop spatter and slag from landing in the boot or lodging in the laces, where it can burn through to the foot and be hard to remove.
Trouser legs should go over the boots and spats, not tucked in. Spats with a quick-release fastening can be taken off quickly if hot metal gets into them. Safety footwear is still needed, as spats do not protect against impact or crushing.