Delta 90 SFA with FA Pressure Flow Parts FAQs
Spares for a compressed-air-fed welding helmet with a pressure flow control: silencers, seals, covers, lenses, headband parts and how to pick the right ones.
How do I identify the right spare for a compressed-air-fed welding helmet?
Check the label or markings on the helmet, the powered air unit, the filter and the old part, then compare them with the parts list in the manual. Helmet generations, powered unit types and filter types can differ, so a part that looks the same may not fit or may not be approved for your system.
Only the parts the maker specifies should be used with the equipment, because other parts can leave the protection below the stated standard. Replacement parts should ideally come from the original manufacturer. If the markings are worn away, check with the supplier before buying, describing the helmet and unit and any numbers still readable.
How do I carry out the airflow test and why is it done before every use?
A flow check is needed before every use because a powered helmet only protects when enough air reaches the wearer, and checking the battery charge and flow rate are key maintenance tasks for powered devices. The method depends on the unit: some use a flow meter held upright with the indicator in a marked zone, while others have you briefly block the hose end and check that the alarm sounds and the blower reacts. Follow your own manual.
If the check fails or an alarm sounds, do not weld in the helmet. Look for a clogged filter, a flat battery, hose damage or leaks. An alarm is a warning, not a replacement for the check.
How should the battery and charger be looked after?
Checking the battery charge is a key maintenance task for powered devices, so check it before each shift. Charge a new battery fully before first use.
Use the charger only for its intended purpose and with the battery type it is made for, keep it indoors and protected from damp, never charge where there is a risk of explosion, and unplug it when it is not in use. If a fully charged battery no longer holds its charge, replace it. Do not use a damaged battery or charger. For long storage follow the manual on charge level and storage conditions.
What do the face seal and head cover do, and how do I know they are worn?
The face seal and head cover help hold air inside the helmet and keep sparks and fume away from the neck and hair. If the seal is damaged, loose or does not sit properly, air can leak and protection falls.
Inspect both before each use for splits, hardening, burns, stretched areas and poor fit. Replace them if they are damaged. A beard or long hair that interrupts the seal reduces protection, and not all helmets are recommended for use with them. Fit the replacement exactly as shown in the manual, and fully dry any part after washing.