0 items in your basket
Total £ 0.00 EX VAT
Multi Process Welders
MIG Torches
TIG Torches
Welding Helmets
Welding Gloves & Clothing
MMA Electrodes
MIG Wire
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Spares for a water-cooled MIG torch: what to check on the cooling side, the neck and the front end, and how to choose and fit parts.
On top of the usual tip, nozzle and liner checks, look after the cooling circuit. Check the coolant level regularly, look at the colour of the coolant (discolouration suggests contamination), and inspect hoses and connections for chafing, kinks and small leaks.Let coolant reach the front of the torch before you start welding, and make sure the lines are not kinked or pinched. Weak flow, a blocked filter or low coolant can overheat internal parts quickly, so follow the machine and torch maker's instructions for flow.
Look for dampness around the neck connection, drips under the torch, or coolant at the rear connection. A common cause is a dried, cracked or flattened O-ring, which can appear after many heat cycles or when the neck has been changed several times.Switch off and let the torch cool, then check the O-rings, lubricate them lightly and replace any that are dry or cracked. A coolant leak can also cause arcing inside the torch and spoil the weld, so stop welding and fix it before carrying on. Follow the manual for the correct O-ring type.
Higher-current work puts more heat into the tip and nozzle. Tips made from harder, heat-resistant copper alloys hold their shape better than plain copper at higher temperatures, and heavier nozzles are made for the larger front end. Their life still depends on current, duty cycle, cooling and spatter.Match the tip to the wire diameter and the nozzle to the torch and the current you weld at. Nozzle material and size ratings differ between makers, so check the torch data plate and manual for the rating rather than assuming one nozzle suits every current.
Common causes are a tip that is only hand-tight, which creates resistance and heat; a tip bore that is too large for the wire, which causes micro-arcing; and a front end that is loose or dirty. Blue or purple threads on a removed tip suggest it was running hot because it was not tight enough.Tighten the tip with the correct tool to the maker's guidance, check the diffuser and tip holder bores are free of spatter, and make sure coolant is flowing properly. Do not file the bore.