Rapid Ref : 4160.550.W

Optrel Tight-fit Halfmask for TM3 Protection - Small
4160.550.W

Name: Optrel Tight-fit Halfmask for TM3 Protection - Small
SKU: 4160.550.W
Price: 95.80 GBP

£95.80 EX VAT

Buy in 3 easy interest free payments of £31.93^† with

With the Half Mask Tight-fit for the Swiss Air PAPR system, you can increase your respiratory protection to the highest possible level with masks and hoods. The silicone mask is close-fitting and guarantees protection level TM3.

Protection factor of 2000 in normal operation
With the half mask tight-fit, we guarantee respiratory protection with a protection factor of 1000 even when the blower is not running
Thanks to the viewing window in front of your mouth, conversations with colleagues are easier
And Swiss air remains Swiss air: Lightweight, compatible with all standard protection products and helmet independent

*Please note that your face must be clean-shaven for TM3 protection, and the fit must be tested for a tight seal.

Brochures & Manuals

BROCHURES & MANUALS

View Brochure

Optrel Panoramaxx CLT 2.0 with e3000X System Parts FAQs

Spares and add-ons for a powered air welding helmet system: how to pick the right part and when to change it.

How do I check a part is right for my powered air helmet system?

Start with the data plate or label on the blower unit and helmet, and the manual that came with the system. These give the system name and part references. If you still have the old part, look for a reference printed or moulded on it and match it exactly.

Helmet parts, blower parts and battery parts are usually different families, so say which one you are replacing. Be wary of mixing parts from another system, because filters, seals and connectors are normally designed to work together. If you are unsure, our team can help you check before you order.

Do I still need extraction if I wear a powered air helmet?

Usually yes. The HSE's welding fume guidance says to avoid or reduce exposure first, then use local exhaust ventilation to take fume away at source, and then add suitable respiratory protective equipment where extraction cannot give adequate control. Outdoors, where extraction does not work well, suitable RPE is expected.

So a powered helmet and its filters are one layer of control, not a replacement for extraction indoors. Your risk assessment decides what is needed for your process, metal and location, so check it before relying on the helmet alone.

What does a spark protector do, and when should I replace it?

A spark protector is a screen that sits in front of the filter so that sparks and spatter do not burn into it or reach the blower. It is a wearing part: it takes the hits that would otherwise damage the filter.

Makers generally say to replace it if it is bent, burnt through, clogged or no longer seats properly, and not to run the system without it fitted. How often depends on the process, so look at it regularly rather than waiting for a set period. Always check the manual for the right type for your system.

Can I use a magnifying lens inside my helmet?

Many helmets have a clip-in or snap-in magnifying lens, sometimes called a reading or cheater lens, in set strengths. It is meant to let you see close work clearly without reading glasses, but only a lens made for your helmet will sit and seal properly.

Check the manual for which strengths and fitting method suit your helmet, and choose a strength that gives a clear view at your normal working distance. Do not fit a lens that does not seat firmly, and fit it only as the manual describes so the main viewing window and seals are not disturbed. If vision is poor, see an optician.

See all 6 questions for this category