0 items in your basket
Total £ 0.00 EX VAT
Multi Process Welders
MIG Torches
TIG Torches
Welding Helmets
Welding Gloves & Clothing
MMA Electrodes
MIG Wire
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Spares and add-ons for a powered air welding helmet system: how to pick the right part and when to change it.
Usually yes. The HSE's welding fume guidance says to avoid or reduce exposure first, then use local exhaust ventilation to take fume away at source, and then add suitable respiratory protective equipment where extraction cannot give adequate control. Outdoors, where extraction does not work well, suitable RPE is expected.So a powered helmet and its filters are one layer of control, not a replacement for extraction indoors. Your risk assessment decides what is needed for your process, metal and location, so check it before relying on the helmet alone.
A spark protector is a screen that sits in front of the filter so that sparks and spatter do not burn into it or reach the blower. It is a wearing part: it takes the hits that would otherwise damage the filter.Makers generally say to replace it if it is bent, burnt through, clogged or no longer seats properly, and not to run the system without it fitted. How often depends on the process, so look at it regularly rather than waiting for a set period. Always check the manual for the right type for your system.
No. In welding systems the particle filter is what deals with the fume. A carbon layer or filter is added to take out some odours and certain gases, ozone being the usual example, but only within its limits and only for what the maker rates it for.A particle filter does not stop gases, so do not assume a standard system covers them. If gases or strong smells are a concern in your work, check the maker's rating for the filter, your risk assessment and the fume guidance for your process before choosing one.
Many helmets have a clip-in or snap-in magnifying lens, sometimes called a reading or cheater lens, in set strengths. It is meant to let you see close work clearly without reading glasses, but only a lens made for your helmet will sit and seal properly.Check the manual for which strengths and fitting method suit your helmet, and choose a strength that gives a clear view at your normal working distance. Do not fit a lens that does not seat firmly, and fit it only as the manual describes so the main viewing window and seals are not disturbed. If vision is poor, see an optician.
