0 items in your basket
Total £ 0.00 EX VAT
Multi Process Welders
MIG Torches
TIG Torches
Welding Helmets
Welding Gloves & Clothing
MMA Electrodes
MIG Wire
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Plain answers on choosing, fitting and looking after the wearing parts of a hand-held plasma cutting torch.
On most hand-held plasma torches the consumables are the electrode, the nozzle (sometimes called the tip), the swirl ring, the retaining cap and the shield cap. The electrode and nozzle create and focus the arc, so they wear fastest. The shield cap protects the parts behind it, and the swirl ring controls how the gas flows around the arc.Some torches also have small O-rings and other seals that should be checked whenever the torch is stripped down. Your manual shows exactly which parts your torch uses and the order they fit in.
Start with the torch itself, not the cutter. Check the torch model and the parts diagram or consumable chart in the manual, then match the part numbers on your old parts to the chart. This matters most on a second-hand machine, where the torch may not be the one the machine originally left the factory with.Parts are normally rated for a particular cutting current, and a part rated lower than the current you cut at will burn out quickly. Do not mix parts from different torch types because they look similar. If you are unsure, our team can help you match a part number.
Often, yes. A shield cap that is undamaged can usually be cleaned of molten metal spatter and reused. Check the hole in the middle: if it is still round and the cap has no cracks, erosion or melted areas, it can go back on. If it is damaged, replace it.Use the cleaning tools the maker recommends, because the wrong tool can scratch or enlarge the parts. Clean the retaining cap and the seating faces too, so that the parts sit squarely and the gas cannot escape around them.
The swirl ring spins the gas around the arc so that it is stable and cools the parts. Clogged or cracked gas holes make the cut worse and can shorten the life of the electrode and nozzle. A swirl ring that has been dropped can chip or crack, so check it by eye every time you change the electrode.Check O-rings for cuts, flattening and dryness. Use only a very light coat of the lubricant the maker recommends, never general grease, because too much lubricant can clog holes and cause arcing. The right replacement interval depends on the torch and how it is used.
