0 items in your basket
Total £ 0.00 EX VAT
Multi Process Welders
MIG Torches
TIG Torches
Welding Helmets
Welding Gloves & Clothing
MMA Electrodes
MIG Wire
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Practical answers on the wearing parts of a light-duty hand plasma torch: what each one does, how to spot wear and how to choose the right replacement.
Start with the data plate on the cutter and the torch, then the manual's parts list. Consumables are specific to the torch design and are usually matched to a current rating, so a part that looks similar may not suit your torch.If you have lost the manual, read any markings or part numbers on the old electrode, nozzle or cap, and compare them with the manufacturer's parts chart. This matters most on used or refurbished machines, where the torch may not be the original one. Our team can help you match parts if you are unsure.
An electrode has a small insert at its tip that slowly erodes into a pit with use. Once the pit is too deep, the arc can attach to the copper behind it and damage the part, so replace it before that point.Makers publish a pit depth limit that depends on the torch and current, so use the figure in your manual. Also replace it if the pit is wide, uneven or rough, or if cut quality has dropped. A small pit gauge or a straight edge and a good light help you judge depth. Always switch the machine off and let the torch cool first.
The gas distributor sits between the electrode and the nozzle. Its small angled holes make the gas swirl around the arc, which helps centre the arc in the nozzle and cool the parts. It also keeps the electrode and nozzle apart electrically.It wears slowly, but inspect it every time you change other parts. Replace it if it has chips or cracks, if any gas holes are blocked, or if its O-rings are damaged. A damaged one can make the arc wander and spoil the cut edge.
The nozzle's centre hole focuses the arc. Look for erosion, a hole that is no longer round, blocked gas holes or damaged O-rings, and replace it if you see any of these. A magnifying glass or loupe helps, and comparing it with a new nozzle shows small changes.In use, a worn nozzle often gives a wider cut, more dross on the underside and an angled (bevelled) edge. Poor height, speed or settings can cause similar faults, so check those too before blaming the nozzle.
