0 items in your basket
Total £ 0.00 EX VAT
Multi Process Welders
MIG Torches
TIG Torches
Welding Helmets
Welding Gloves & Clothing
MMA Electrodes
MIG Wire
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
The ACX control panel includes all the features of the basic ACS panel, but you also receive several functions that simplify and speed up welding.
Internal and external spares for an AC/DC TIG inverter power source: how to identify the right part, what fails, and how to work safely.
Start with the rating plate on the machine, which gives information about the manufacturer, supply requirements, performance and suitability for use. Note the type, serial number and any version marking, then find the matching parts list or service documentation from the maker.The part number printed on the old item, where there is one, helps confirm the match, but do not rely on appearance alone. Boards, diodes, transformers and connectors often look alike while differing in ratings or fit between versions. If you are unsure, our team can help you work out which part your machine's documentation points to.
An inverter power source converts the mains AC to high-frequency AC, steps it down through a transformer to welding voltage, and then rectifies it to DC. So the main groups are the input stage and its protection, the switching or power board, the high-frequency transformer, the output rectifier (often a diode board or card), the control electronics, and the output connections.On an AC/DC machine there is additional circuitry to produce the AC output. Spares are usually listed by these groups in the maker's parts list. The exact layout differs from model to model, so use your own documentation.
The HSE says to stop using equipment immediately if it appears to be faulty and have it checked by a competent person. Signs to take it out of use include a damaged plug or connector, a cable that is loose or has been repaired with tape, internal wires showing, and burn marks or stains that suggest overheating.For a TIG inverter, also watch for a tripped supply protection device, a burning smell, unusual noises, error codes that keep returning, loss of output or an unstable arc. Do not keep trying the machine, and do not remove covers to investigate unless you are qualified.
A varistor is a protective part that is intended to limit short voltage spikes so they do not reach the more sensitive electronics. Repair accounts commonly find that a varistor on the mains input has failed after a surge, sometimes along with a fuse or breaker tripping.Because it is protective, a failed varistor should be replaced with the correct type as specified in the maker's parts list. Leaving it out or fitting a part with a different rating removes protection for the rest of the machine. As with other internal parts, the work should be done by a competent person, and the cause of the failure should be looked into.
