Kemppi Kempact 181A Machine Parts FAQs
Spare parts for an inverter MIG/MAG welding machine: cooling fan, gas valve, circuit cards and supports, door, latch and handles.
How do I work out which spare part fits my welding machine?
Start with the rating plate on the machine. It gives the manufacturer, the supply requirements, the performance and the standard the machine was built to, and often it is the only information you have if the manual has been lost. Note the type designation, the serial number and any part number, and write down any marking or number on the old part.
Serial numbers often matter because a machine can change during its production life, so check the maker's parts list against the serial number where you can. Compare the old and new part for size, connector and fixing points before fitting. If you are unsure, our team can help you match the part.
Do I need to isolate the machine before fitting a part?
Yes. Switch the machine off and disconnect it from the mains supply before you open any panel or door, and make sure it cannot be switched back on while you are working. HSE guidance on electrical work says isolation must be secure so that energy cannot be re-introduced into the equipment.
Some parts inside an inverter machine, such as capacitors, can hold a charge for a time, so follow the maker's service instructions on waiting and checking before touching anything. If you are not sure it is safe, stop and ask a competent person to do the work.
Should the machine be tested after a repair?
Yes. The standard for in-service inspection and testing of arc welding power sources covers test procedures for periodic inspection and for testing after repair, to confirm electrical safety. It also says the same procedures can be used for maintenance.
The tests, such as insulation and protective conductor checks, need the right instruments and a competent person, and the results should be recorded. Do not return a machine to service after opening it or replacing power-side parts until it has been checked. Ask the maker or a service agent what applies to your machine and how often it should be tested in use.
What are the signs of a failing cooling fan, and what damages it?
Common signs are a fan that is noisy, runs at full speed all the time, runs slowly, stops, or a machine that cuts out on its thermal protection after only a short period of welding. A fan that is not moving enough air lets the power parts overheat.
Dust and metal particles are a frequent cause, because the fan pulls them into the machine. Working beyond the duty cycle on the rating plate also shortens the life of the machine. If the fan turns freely but the machine still overheats, blocked airways or dirty heat sinks may be the cause. Isolate the machine before looking inside.