Kemppi Kempact 181A Machine Parts FAQs
Spare parts for an inverter MIG/MAG welding machine: cooling fan, gas valve, circuit cards and supports, door, latch and handles.
How do I work out which spare part fits my welding machine?
Start with the rating plate on the machine. It gives the manufacturer, the supply requirements, the performance and the standard the machine was built to, and often it is the only information you have if the manual has been lost. Note the type designation, the serial number and any part number, and write down any marking or number on the old part.
Serial numbers often matter because a machine can change during its production life, so check the maker's parts list against the serial number where you can. Compare the old and new part for size, connector and fixing points before fitting. If you are unsure, our team can help you match the part.
Who should fit electrical and electronic parts?
Simple mechanical parts such as handles or a door latch are usually straightforward, but anything that connects to the mains or the power circuits should be fitted by someone competent. HSE says people working on electrical equipment must be competent, which means suitable training and experience for the job and the complexity of the task.
If you cannot show that, the work should be supervised by someone who can. Follow the maker's service manual, and use the right replacement part, not a near match. When in doubt about a power-side part, have the machine repaired by a competent service engineer.
What are the signs of a failing cooling fan, and what damages it?
Common signs are a fan that is noisy, runs at full speed all the time, runs slowly, stops, or a machine that cuts out on its thermal protection after only a short period of welding. A fan that is not moving enough air lets the power parts overheat.
Dust and metal particles are a frequent cause, because the fan pulls them into the machine. Working beyond the duty cycle on the rating plate also shortens the life of the machine. If the fan turns freely but the machine still overheats, blocked airways or dirty heat sinks may be the cause. Isolate the machine before looking inside.
How do I choose a replacement cooling fan?
Use the old fan as your reference, and check the label for its voltage and type (DC or AC), size and thickness, connector or wire length, and the direction of airflow. Fitting the wrong airflow direction or a lower-output fan means the machine will cool less well even though the fan runs.
It is best to use the part the maker lists for your machine, because the control board may monitor the fan or adjust its speed. Check the fixing holes match and that the fan cannot touch wires or the case. Make a note of how the old fan was oriented before removing it, and fit the new one the same way.