0 items in your basket
Total £ 0.00 EX VAT
Multi Process Welders
MIG Torches
TIG Torches
Welding Helmets
Welding Gloves & Clothing
MMA Electrodes
MIG Wire
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Spares and consumables for a powered or air-fed welding helmet system: how to identify the right part, what wears, and how to look after it.
Start with the user manual and the markings on the unit and on the old part. The manual's parts list or exploded diagram will show the exact type, and the part number on the worn item (or the system's own label) helps confirm it. Note the helmet or system type and any serial or version details before you order.The HSE advises that, ideally, replacement parts come from the original manufacturer of the equipment, so that the system keeps performing as the maker intended. Parts that look the same can differ in fit, flow or approval, so check compatibility with the maker rather than guessing from appearance. If you are unsure, our team can help you match a part to your system.
Filters have a limited capacity and can clog, which makes breathing harder and reduces airflow, so the HSE says replaceable filters should be changed when necessary. Follow the maker's instructions for your system. Common signs are a filter indicator showing it is loaded, a low-flow alarm, a noticeably shorter battery run-time, or visible damage or dirt.A maker's consumables guide notes that a pre-filter is usually changed far more often than the main particle filter, which helps the main filter last. Gas or vapour filters should be replaced according to your risk assessment and the maker's guidance, and you should not wait until you can smell something.
The hose carries the air you breathe, so it must be the right type for your system and your job. Different hoses are designed for different equipment, and the HSE warns that light-duty supply tubes must never be used for normal airline applications. The connectors, length and any pressure or flow requirements also depend on the maker's design.Check the manual for the correct hose type, and look at the whole length and the end fittings before each use for cuts, kinks, crushing, burns from spatter and loose connections. Replace a damaged hose rather than taping it. The HSE says to look after the supply tube during use, because the wearer's protection depends on it.
Follow the maker's cleaning advice. The HSE says that using cleaning products other than those the maker recommends may cause problems with the equipment, so avoid solvents and harsh chemicals unless the manual allows them. Clean and dry parts in a clean area so they are not contaminated again.The HSE also advises cleaning equipment before it is stored, and storing it as the maker instructs, in a clean place that protects it from contamination, damage and deterioration. Keep the helmet from resting face down on the cover lens, and remove or disconnect the battery for long-term storage if the manual says so. Check the parts again before the next use.
