Rapid Ref : GXE405G

Kemppi Flexlite GXe K5 405G Air Cooled 400A MIG Torch, with Euro Connection
GXE405G

Name: Kemppi Flexlite GXe K5 405G Air Cooled 400A MIG Torch, with Euro Connection
SKU: GXE405G

Select Option

Prices From £342.20 ex VAT

Shop Parts

REDESIGNED WITH OVER 200 IMPROVEMENTS

The Flexlite GXe is a reliable, high-quality MIG/MAG torch series with optimised ergonomics and excellent welding performance. The improved structure enables a longer, cost-efficient lifetime for both the torch and consumables, proved by a 6-month warranty.

Long, cost-efficient lifetime
IP5X Protected against dust and humidity
Improved handle grip features and shape for better ergonomics
New lightweight on-torch remote control options
Redesigned and patented ball-joint cable is optimised for smoother wireline and reduces wrist load
Over 200 improvements made to the previous version (GX-series)
Compatible with all GX-series consumables

Brochures & Manuals

BROCHURES & MANUALS

View Brochure

Kemppi Flexlite GXe MIG Torches Declaration Of Conformity

Kemppi Flexlite GXe MIG Torches Operating Manual

Flexlite K5 Torches FAQs

Answers for buyers of air-cooled and water-cooled MIG/MAG torches with a Euro connector and a hose package: choosing, coolant, set-up and care.

Should I choose an air-cooled or water-cooled torch?

Air-cooled torches use the surrounding air and the shielding gas to carry heat away. They need no cooler or extra hoses, so they are simpler to set up, maintain and move, which suits field work. Their cables are heavier and less flexible at higher currents.

Water-cooled torches circulate coolant through a cooler, which gives a lighter, more flexible cable for the same current and is the usual choice for sustained high-current work, though it adds equipment and upkeep. Decide on your typical current and how long you weld at it, and check the rating at your duty cycle.

What coolant should I use in a water-cooled torch?

Use a coolant made for welding torches and follow the cooler maker's instructions. Many makers advise against plain tap water: its conductivity can cause electrochemical corrosion that damages the torch and other equipment, and minerals can leave scale in the hoses. Check your cooler and torch manuals before using anything else.

Check the coolant regularly and replace it if it is contaminated, because particles can clog the cooling channels. Some makers also give a conductivity limit for the coolant, so check the manuals for how often to test it and what to replace it with.

What should I check before starting each day on a water-cooled torch?

Check that the torch is securely connected, that the hose package and torch neck show no damage, bends or impact marks, and that the coolant level is adequate. Make sure the liner suits the wire material and diameter you are about to use.

Allow time for the coolant to fill the system before you weld at high current, and look for leaks at the hose connections. If the cooler gives a flow or temperature warning, stop welding and find the cause before carrying on.

How should I look after the hose package and cable?

Lay it out loosely and avoid sharp bends, crushing and pulling. Tight bends raise friction on the wire and wear the liner faster, and a crushed or kinked hose can restrict gas flow or coolant flow.

Choose a length that suits the job, because a package that is too short is strained and one that is much too long adds wear and drag. Do not run trolleys or vehicles over it, and do not use it to pull the torch around. Check it for cuts and kinks as part of your pre-use inspection.

See all 6 questions for this category