Flexlite GX 403W Parts FAQs
Spares for a water-cooled MIG torch: what to check on the cooling side, the neck and the front end, and how to choose and fit parts.
What extra checks does a water-cooled MIG torch need compared with an air-cooled one?
On top of the usual tip, nozzle and liner checks, look after the cooling circuit. Check the coolant level regularly, look at the colour of the coolant (discolouration suggests contamination), and inspect hoses and connections for chafing, kinks and small leaks.
Let coolant reach the front of the torch before you start welding, and make sure the lines are not kinked or pinched. Weak flow, a blocked filter or low coolant can overheat internal parts quickly, so follow the machine and torch maker's instructions for flow.
Why should I not bend or hammer the torch neck?
Bending, dinting or hammering the neck can restrict the coolant passage, and reduced coolant flow may not always trigger a fault warning on the machine. Hammering the nozzle or neck to knock off spatter can also damage the insulator, tip holder and diffuser, and on water-cooled necks it can cause leaks and arcing.
If the neck is dented, pinched or its insulator is broken, replace it. Clear spatter with a proper tool instead, and keep the neck bend as the maker designed it.
How do I spot and fix a coolant leak at the neck?
Look for dampness around the neck connection, drips under the torch, or coolant at the rear connection. A common cause is a dried, cracked or flattened O-ring, which can appear after many heat cycles or when the neck has been changed several times.
Switch off and let the torch cool, then check the O-rings, lubricate them lightly and replace any that are dry or cracked. A coolant leak can also cause arcing inside the torch and spoil the weld, so stop welding and fix it before carrying on. Follow the manual for the correct O-ring type.
Why use heavy duty contact tips and nozzles on a high-current torch?
Higher-current work puts more heat into the tip and nozzle. Tips made from harder, heat-resistant copper alloys hold their shape better than plain copper at higher temperatures, and heavier nozzles are made for the larger front end. Their life still depends on current, duty cycle, cooling and spatter.
Match the tip to the wire diameter and the nozzle to the torch and the current you weld at. Nozzle material and size ratings differ between makers, so check the torch data plate and manual for the rating rather than assuming one nozzle suits every current.