Fronius MMA Cable Sets FAQs
Cable sets for manual metal arc (stick) welding: what they contain and how to choose, fit and look after the leads, plugs, holder and clamp.
Does lead length matter?
Yes. The electrode lead and the return lead together form the welding circuit, and the total length of both is what counts. Longer runs lose more voltage along the cable, so longer leads usually need a larger cross-section to compensate.
Use leads only as long as the job needs. If you regularly work a long way from the machine, step up to a larger cable size instead of simply joining extra lengths, and check connections, as each joint adds resistance. Check your machine's manual for any maximum lead length it recommends.
How do I know which plug size I need?
Plugs are sized to suit the cable cross-section, and each plug size covers a range of cable sizes, so check the range given by the plug maker. The plug must also match the socket on the welding machine, so check the machine's manual for the socket type.
Choose a plug that suits both the cable size and the current it will carry. A plug that is a poor fit for the cable, or one that is not fully inserted and locked, can make a poor connection that gets hot. Fit and tighten plugs so they make full contact. Labelling varies between makers, so if you are unsure, check the plug maker's details.
What should I look for in an electrode holder?
Choose a holder rated for at least the maximum current of your machine, and make sure the jaw opening takes the largest electrode diameter you will use. Fully insulated holders are recommended so that no bare metal can be touched by accident.
Jaw styles differ. Some hold the electrode very firmly but are slower to change, while spring or lever types are quicker to use. Check the grip is comfortable and the cable connection is secure. Replace a holder that has damaged insulation, worn jaws or a loose cable entry.
Where should the return clamp be connected?
Connect it to the workpiece as close to the arc as is practical, onto clean, bright metal. Remove rust, paint, mill scale or primer where the clamp bites, because these conduct poorly and add resistance.
Do not let the return current pass through metal rails, pipes or frames that are not part of the workpiece. Keep the clamp tight, as a weak spring is a common cause of poor contact. Check the clamp is rated for the current in use, as an undersized clamp can overheat.