Bester Feed Rolls FAQs
Straight answers to the questions people ask most when choosing and looking after replacement feed rolls for a MIG wire feeder.
Why do aluminium wires need a U-groove roll?
Aluminium wire is soft and deforms easily if it is squeezed too hard. A smooth U-shaped groove cradles the wire and holds its round shape, so it feeds steadily without being flattened or shaved.
A V-groove or knurled roll can mark or distort aluminium wire. Aluminium also usually feeds best with a plastic liner and a short, straight cable, so check those parts when you change over. A roll alone will not cure feeding trouble on a long torch.
How do I know which side of the roll to use?
Many rolls have two grooves, one on each face, for two neighbouring wire sizes. The size is normally marked on the roll. The side facing outward or inward depends on your feeder, so follow the manual.
Fitting the roll with the wrong size groove in the working position over-tightens or loosens the grip on the wire, which causes slipping, deformed wire and poor feeding. Always check the size marking against the wire diameter every time you change roll or wire.
How tight should the feed roll tension be?
Tighten only until the wire feeds without slipping. A common way to set it is to feed about 50 mm of wire past a cold torch tip, back the tension off until the rolls slip when you press the trigger, then add about half a turn at a time until the wire feeds smoothly. Wear gloves and keep the torch pointed away from you and from anything conductive.
Too little tension lets the wire slip. Too much deforms the wire and can lead to birdnesting if anything restricts it further down. Your welder's manual may give a recommended setting.
How do I tell when feed rolls are worn out?
Signs include the wire slipping or feeding unevenly even though the tension seems right, a polished or flattened groove, or knurling that has worn smooth. Worn rolls make it hard to reach the right pressure, and wear tempts people to keep tightening the tension, which deforms the wire.
Inspect the rolls regularly, for example whenever you fit a new spool, and clean or replace any that are deformed. There is no fixed life, so replace them when feeding turns erratic with the right settings. Check the liner, guides and contact tip too, as they can cause the same symptoms.