Flexlite GC 323G Parts FAQs
Front-end parts, necks and liners for a gas-cooled MIG torch, and how to choose between the versions of each.
How should I fit and trim a replacement liner?
Follow the torch maker's instructions, because the trim length belongs to the torch and liner. Improper trimming, either too short or too long, can cause bird-nesting and wire feeding trouble. Straighten the torch cable and keep it fully extended when you fit and trim the liner, because a twisted cable can leave the liner too short once it is straightened.
Trim to the maker's gauge or stated length, and check the cut end is not burred or pinched, as a burred liner can also upset feeding. Any trim figure quoted for one maker's liner should not be copied for another.
How does poor nozzle cleaning lead to weld porosity?
Spatter can build up in the nozzle and on the contact tip and diffuser, restricting the shielding gas or making it turbulent. Poor gas coverage is one of the most common causes of porosity, because air can reach the weld pool.
Check the nozzle regularly and remove spatter with welder's pliers or the cleaning tool the maker recommends, and replace the nozzle if it is damaged. Make sure the gas ports in the diffuser or adaptor are clear. Rough cleaning tools shorten nozzle life, and too much anti-spatter compound can also contaminate the gas and damage the nozzle insulation.
Does contact tip material matter, and are there tips for different wires?
Contact tips are made from electrolytic copper or from harder copper alloys such as copper-chromium-zirconium. Electrolytic copper suits lower current and wears faster, while the harder alloy is the usual choice for medium to high current and for abrasive wires such as cored wire.
Most tip materials can be used with most wires, though aluminium may need a slightly larger bore, and some torch makers list separate tips for steel and stainless wire, so follow the data for your torch. Match the bore to the wire diameter and replace the tip when the bore wears oval or the wire feeds badly.
How do I know when the torch neck needs replacing?
Look for a neck that is bent, dented or visibly damaged, with worn or stripped threads or a seat that no longer holds the front-end parts firmly. A damaged neck can pinch the liner and upset wire feeding. Overheating, a loose front end or poor gas coverage can be other warning signs.
Liner wear is often concentrated around the neck, so check the liner when you change the neck. A discoloured liner and a drop in current can point to poor connection. This is general guidance, as the signs vary with the design, and if you are unsure, fit the neck specified for your torch.