Rapid Ref : Lincoln6Pin-LA-RC

CK Amptrak Linear Amperage Control with Velcro Straps for Lincoln Electric Machines, 6 pin Plug
Lincoln6Pin-LA-RC

Name: CK Amptrak Linear Amperage Control with Velcro Straps for Lincoln Electric Machines, 6 pin Plug
SKU: Lincoln6Pin-LA-RC

Select Option

Prices From £236.67 ex VAT

The Amptrak™ remote current control provides remote on-off control of the welding machine contactor and/or gas and water solenoid control, as well as a full range current output control. The fitted Velcro straps are a one size fits all solution that can be easily retrofitted to all torch handle diameters. A built in strain-relief prevents the control cord from being pulled out or damaged.

Linear slide actuator for complete on/off and full amperage control
Velcro strap attachment to fit all TIG torches
Adapts to most standard TIG power supplies
Protected against high frequency

Compatible with Lincoln Electric Machines, 10K Ohm Potentiometer rating, 6 Pin Plug.

Product Details

Lincoln Electric Machine Remotes FAQs

Foot pedals and hand-held amperage controls that plug into a compatible TIG machine, and how to get the best from them.

What does the pedal do through its full travel?

On a TIG foot pedal, pressing down raises the welding current. Pressing it fully down gives the maximum current that has been set, and lifting your foot right off ends the weld and starts the post-flow gas cycle.

In between, you are feathering the current, for example to build heat as you start and to ease off at the end of a run. Always check the machine's manual to see exactly how your pedal behaves, because start and finish settings differ from machine to machine.

Do I have to switch the machine to remote before the pedal works?

Usually yes. Most TIG machines need to be set to take their current (and often their output on and off) from a remote control. Depending on the machine this is a panel switch, a menu setting or a button sequence.

If the pedal is plugged in but the machine ignores it, or the arc will not start, check that the remote or contactor setting is selected before blaming the pedal. If you are not using a remote, the setting often needs to go back to the normal position. Your machine's manual will show the exact steps.

Is it safe to change the tungsten or cup while the pedal is plugged in?

Switch the machine off at the power source before changing the tungsten electrode or the gas cup. Pedals and torch switches can start the arc, and on a machine with high-frequency start that means a high-voltage pulse at the torch, so an accidental press is a real hazard.

Keep your foot clear of the pedal while you work at the torch. Damaged torches or leads, such as ones repaired with insulating tape, are a risk, so replace them. Follow the manufacturer's instructions and your own risk assessment.

How should I check a remote lead and plug for damage?

Before each session, look along the whole lead for cuts, abrasions, kinks or exposed wire, and check the plug for bent or loose pins, cracks and a loose cable clamp. Look over the pedal or hand control housing as well, including the pedal's moving parts.

Do not use a damaged lead or plug. Have it repaired or replaced, as a failing connection can cause erratic current and, in the worst case, an electrical hazard. Coil the lead loosely when it is stored, and do not tug on it by the cable to unplug it.

See all 6 questions for this category