0 items in your basket
Total £ 0.00 EX VAT
Multi Process Welders
MIG Torches
TIG Torches
Welding Helmets
Welding Gloves & Clothing
MMA Electrodes
MIG Wire
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Cup Pyrex Size 8, 1/2" x 1-9/32", 12.7mm x 32.6mm.
Practical answers on choosing, fitting and looking after the individual parts of a larger gas saver torch set-up.
Usually not. Collets, bodies, insulators, back caps and cups are made to fit one particular torch series, and parts from a different series, or from a standard set-up without a gas lens, often will not thread together or seal properly. Even a part that seems to fit can leave a small gap that lets air into the shielding gas.Match every part to the torch series given in the torch manual or marked on the old part. When several parts need replacing, changing them as a matching group is the safest way to avoid mismatches.
The O-ring seals the rear of the torch head so shielding gas cannot leak out and air cannot be drawn in. Heat and repeated tightening and loosening can make it dry out, crack or flatten.Signs include a visible crack, a flattened or pinched ring, or porosity and discolouration in the weld that you cannot trace to gas flow, draughts or cleanliness. Use an O-ring that matches the cap and torch series, check that the groove is clean, and seat the ring so it is not pinched as the cap goes on. If in doubt, fit a new O-ring whenever you replace the back cap.
These are two separate choices. A standard collet is slotted and is squeezed onto the tungsten as the back cap is tightened. A wedge collet is a single piece with an angled end that presses against the collet body, and it is usually described as more durable than a slotted type.Stubby (short) describes length. A shorter collet normally goes with a shorter gas lens body and helps access in tight joints, while a standard-length collet goes with a standard body. Lengths differ between makers, so confirm the collet suits your lens body and tungsten diameter before choosing, and check the torch manual if the fit is unclear.
A larger lens body and cup spread a wider blanket of shielding gas, and a gas lens generally lets the tungsten stick out further while keeping good cover. Makers' technical guidance says larger nozzle diameters give a longer laminar flow, while smaller ones suit tight spaces but raise gas velocity and turbulence.The trade-offs are a bulkier torch head that can block access or your view of the joint, and the need for correctly matched larger parts. Longer stick-out also leaves more tungsten exposed, so pre-flow and post-flow matter. Gas settings depend on the cup, joint and conditions, so follow the torch maker's guidance and test on scrap before welding a real joint.