0 items in your basket
Total £ 0.00 EX VAT
Multi Process Welders
MIG Torches
TIG Torches
Welding Helmets
Welding Gloves & Clothing
MMA Electrodes
MIG Wire
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Answers for buyers choosing and looking after Bluetooth-enabled auto-darkening welding helmets, including those used with a powered air system.
Welding fume is a health risk, and the HSE says that for arc welding a powered or supplied air respirator is the preferred option, ideally one that combines respiratory, eye and face protection with an assigned protection factor of at least 20. A helmet designed to work with a powered air unit gives you that combined protection in one piece of kit.Tight-fitting masks can become uncomfortable, and people then loosen or remove them. A powered system blows filtered air across the face, which many welders find easier to wear for a full shift. Check the unit's data plate and manual to confirm it suits the helmet you choose.
Follow the maker's pre-use checks every time. These normally include a look at the filters, hose and seals for damage, checking the battery level, and testing the airflow with the flow meter or indicator supplied. Many units also have a low-airflow warning, and if yours does you should confirm it works as the manual describes.Do not weld if the airflow check fails or the warning does not work. Replace blocked filters as the manual describes, and keep a spare charged battery if you weld for long periods. The exact test method differs between units, so use the instructions that came with yours.
Reusable respiratory protective equipment needs regular thorough examination and, where appropriate, testing, carried out by properly trained people following the maker's instructions. The HSE's guidance on respiratory protective equipment says this should be monthly, or every three months if the equipment is used less often, with records of examinations, tests and repairs kept.This is separate from the quick check you do yourself before each use. Your employer or safety adviser should set the programme from the maker's instructions and your risk assessment, and worn hoses, seals and filters should be replaced promptly rather than waiting for the next scheduled examination.
The shade range shows how dark the lens can be set when the arc is lit. A lower number lets through more light, which is helpful for low-current work where you need to see detail, while a higher number is darker and suits higher currents. A wide range lets one helmet cover a variety of jobs.The right shade depends on the process and the welding current, and it is normally taken from the shade selection table in the relevant standard or the helmet manual. If the process you use needs a darker or lighter shade than the range allows, that helmet is not suitable for it.
