0 items in your basket
Total £ 0.00 EX VAT
Multi Process Welders
MIG Torches
TIG Torches
Welding Helmets
Welding Gloves & Clothing
MMA Electrodes
MIG Wire
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Straight answers to the questions people ask most when choosing, fitting and looking after a MIG torch tip holder.
Not always. On many torches the tip holder and the gas diffuser are two separate parts: the holder takes the contact tip and the diffuser, which has small gas holes, spreads the shielding gas evenly round the inside of the nozzle. On some torch designs one part does both jobs, and different makers use the words holder, adaptor and diffuser in different ways.So do not rely on the name alone. Check your torch type and the parts list in the torch manual, or compare the old part with the new one before fitting.
Some torches have an exchangeable holder and some have the holder fixed into the neck. A fixed holder usually passes heat away better, but each tip change wears its thread and it cannot be replaced on its own. If that thread fails, the whole neck may need to be changed.An exchangeable holder lets you replace just the worn part. Which type you can fit depends on your torch design, so check the manual before ordering rather than assuming the two are swappable.
Firmly seated, but not forced. The tip should sit flat against its seat in the holder with the threads fully engaged. A loose tip gives poor current transfer, overheats, and may show a blue or violet colour on the thread.Many makers advise tightening by hand and then snugging with the correct tip tool, and warn that over-tightening can damage the tip or the holder. Follow your torch manual. Do not use pliers on the tip, as they can mark the soft copper.
Replace it if the thread is worn or stripped so the tip will not seat firmly, if the tip keeps working loose, if the holder is cracked, burnt or discoloured, or if spatter in the bore or gas holes cannot be cleared. A loose or worn joint is a common reason for contact tips overheating and wearing quickly.There is no fixed time interval. Makers generally advise replacing parts when you can see wear or damage rather than on a schedule. Check the holder and bore for spatter during routine torch checks.